![]() ![]() ![]() Now you are ready to use the card in any POS/ATM.Read the card again and see if all is ok for this simple run the software as admin, enter your card in the Hardware and from the software interface press the button Read Card allow it 15/30 sec and the data will show up if all is ok.Press the button EXIT to exit the software, IMPORTANT DON’T PULL OUT THE CARD WHEN THE SOFTWARE IS OPEN EXIT THE SOFTWARE THEN YOU PULL-OUT THE CARD.Now press Valid data a popup will show up with the data you write in the software interface please check if is correct if it is then press Burn-card Button and allow the software 30/1 Min in order for it to burn the data over the EMV Chip.hex format since the POS/ATM is communicating in.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |